How to deal with the residual glue on the purification board?

 The purification boards can be combined and installed as needed, which can reduce a lot of costs and facilitate installation. However, due to manual work, many construction workers will get glue on the purification boards during construction, so how to deal with it? FRP lighting tiles

       1. Use bananas to drip water on the glue stains, and at the same time use brushes and other scrubbing tools to continuously stir and scrub. After the glue stain becomes soft and falls off, rinse with clean water and scrub repeatedly until it is clean. Stick an absorbent cloth on the back of the material with glue marks, then apply some white vinegar on the glue marks, and wipe clean with cotton dipped in water.

       2. Acetone solution can be washed (but acetone solution is poisonous, so be careful when using it). 502 glue is a kind of resin glue, as long as you use an organic solvent such as acetone to dissolve the resin. However, inhaled acetone is toxic, so be careful how you use it. You can put a part of the glue in the ultra-low temperature environment, and the glue will fall off. If the purification board is covered with 502 glue on a large area and coated with acetone, it can be removed in about 5 to 10 minutes.

       3. If there are glue stains, you can use acetone or banana to drip some water on the glue stains. Brush repeatedly with a brush. After the glue stain has softened and been removed from the material, rinse with clean water. If it fails once, you can scrub it several times and clean it.

     Roofing Material must have the correct installation and use method throughout the use process. Only by using the correct method can the purification board be able to complete the effect, and the use effect can be well guaranteed. If it is used incorrectly, the product will not be able to perform well, which will affect the installation process.